One of our most frequent requests is for the ability to switch faults automatically into LJ Create equipment directly from ClassAct II. We are pleased to announce that the wait is over!
Simply install this file on any PCs with hardware attached - Click to download (1.3 MB)
Tip: If you see this warning screen click More info then Run anyway
With the fault insertion program running and an appropriate piece of hardware connected to the PC, ClassAct II now has the ability to automatically switch in the correct fault when a lesson that requires switched faults is launched.
FAQ
Does it matter if I use multiple pieces of equipment on the same PC?
No, the fault insertion program has the ability to automatically detect the currently-connected hardware. Just connect the piece of equipment that the lesson requires, launch the lesson and you are ready to go.
How do I remove the fault from the hardware when I'm finished?
Simply close the lesson; the fault will automatically be removed.
My panel trainer has a toggle switch for enabling faults, do I need to leave this in the On position?
No, the fault insertion software takes care of that for you so please leave the toggle switch to Off by default.
I can't seem to get things working, is there a troubleshooting or debug mode?
To launch the fault insertion utility in debug mode hold CTRL+SHIFT and double-click the launch shortcut.
Note: this will not work from the Start Menu. To locate the shortcut from the start menu right click it, select More then Open file location.